Multifunction Power Tool Use; Multifunction Power Tool Start-Up - Elite Mt180Kit Manual De Usuario

m t 1 8 0 K i t
Keep Working
12. DO NOT OVERREACH. Keep proper footing and balance at all times.
13. MAINTAIN TOOLS WITH CARE. Keep tools clean for better and safer performance. Follow instructions for lubricating and
changing accessories. Keep hands dry, clean and free from oil and grease.
14. DISCONNECT TOOLS. When not in use, before servicing and when changing any accessories.
15. REMOVE ADJSUTING KEYS AND WRENCHES. Have the habit to check and see that keys and adjusting wrenches are
removed from the tool before turning on.
16. AVOID UNINTENTIONAL STARTING. Do not carry plugged-in tool with finger on switch. Be sure that the switch is off
when plugging in.
17. OUTDOOR EXTENSION CORDS. When the tool is used outdoors, only use extension cords intended for use outdoors
and so marked.
18. STAY ALERT. Watch what you are doing. Use common sense. Do not operate the tool when you are tired.
19. CHECK DAMAGED PARTS. Before using the tool, a guard or other part that is damaged, these must be carefully checked
to ensure that the tool will perform properly the intended function. Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting and any other condition that may affect the tool's operation.
20. DO NOT OPERATE portable electric tools near flammable liquids or in gaseous or explosive atmospheres. Motors in
these tools normally spark, and the sparks may ignite fumes.

2. Multifunction power tool use

This rotary tool can be used for drilling, grinding, sanding and polishing, as well as engraving, cutting and removing rust in
tight spaces or inaccessible places. The tool can be used on most metals, glass, wood and ceramics. For best performance
and results keep the speed as even as possible without exercising too much pressure. As a guideline, use the tool at low
speed for all large accessories, such as polishing for example, and at high speed for smaller accessories such as those used
for engraving. For grinding and engraving, hold the tool as if it were a pen.

3. Multifunction power tool start-up

Never start up or stop the tool is the accessory is in contact with the piece to be worked on. Hold it firmly and press the
ON/OFF switch. The tool will run continuously until the switch is turned to OFF position. The speed can be adjusted while
the tool is running.
KEEP WORKiNG 02