Speed Adjustment; Useful Hints & Tips - Elite Mt180Kit Manual De Usuario

m t 1 8 0 K i t
Keep Working

4. Speed adjustment

The multifunction power tool is equipped with speed control. Do not change the speed while the tool is working. The speed
switch is located on the rear of the tool. Turn it to increase or reduce speed. Use the tool at low speed for polishing and simi-
lar operations, but use higher speed for drilling or cutting action.
IMPORTANT GENERAL SAFETY TIPS!
1. The Tool should be unplugged when changing accessories.
2. If you stall the tool, switch it off immediately.
3. Periodically check the tightness of your collet chuck, especially during prolonged use of the same accessory
4. After use, always disconnect your power tool
5. Do not undertake repair of the power tool your self.
6. Do not leave your tool unattended while switched on.
7. Do not use or store your tool in damp or wet conditions.
5. Useful hints & tips
1. Your rotary tool will become warm after prolonged use and so must be switched off and allowed to cool down.
2. To ensure smooth running, the spindle should be oiled periodically.
3. Do not apply too much radial pressure to the accessory bits while polishing, cleaning, sanding or grinding. By doing this
you will put a strain on the spindle and adversely affect the precision of the tool.
4. Always work with a sensitive touch so as not to impede the efficiency of your mini tool.
5. When drilling metal, always mark the drilling point with a centre punch first, so that your rotary tool does not slip.
6. Always ensure that you have maximum contact between the accessory shaft and the collet chuck.
7. Vary the speed on the tool for the work in hand, low speed for polishing & cleaning and high speed for engraving.
KEEP WORKiNG 03