Uponor Smatrix Wave Guía Rápida página 7

Quick Guide
Installation
1. Attach the full assembly, or parts of it, to the wall
either with a DIN rail or by using wall screws and
plugs.
If the controller is installed inside a metal cabinet,
then locate the antenna outside the cabinet.
2. Connect the antenna to the controller using the
supplied antenna cable (0.5 – 5m, CAT5e/CAT6).
3. Connect the actuators.
4. Check that all wiring is complete and correct:
• Actuators
• Heating/cooling switch
• Circulation pump
5. Ensure that the 230 V AC compartment of the
controller is closed and the fi xing screw is tightened.
6. Connect optional external sensor (compatible
thermostats only).
7. Set DIP switch on public thermostat T-163.
Function*
Standard room thermostat
Standard room thermostat together with a
fl oor temperature sensor
Standard room thermostat, or system device,
together with an outdoor temperature sensor
System device together with a supply
temperature sensor for heating/cooling
switch over function
System device where the sensor input is used
for Comfort/ECO switch over function
Remote sensor
System device where the sensor input is used
for heating/cooling switch-over function
* The thermostat can only be registered as a system device to a
Wave system with multiple controllers, if it is registered to the
master controller.
U P O N O R S M AT R I X WAV E · Q U I C K G U I D E
QUICK GUIDE
Switch
ON DIP
1 2 3 4
ON DIP
1 2 3 4
ON DIP
1 2 3 4
ON DIP
1 2 3 4
ON DIP
1 2 3 4
ON DIP
1 2 3 4
ON DIP
1 2 3 4
8. Insert batteries into the thermostats.
9. Select thermostat control mode (settings menu 04,
in digital thermostats only). Default: RT (standard
room thermostat).
10. Connect the power cable to a 230 V AC wall socket,
or if required by local regulations, to a junction box.
Register thermostats, the interface and other system
devices, in that order (next page).
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SI
SK
7