First Installation - Tethys Fin Manual De Instrucciones

First
installation
EN
1 The device is closed.
2 To open the device, rotate the
device housing (A) counterclock-
wise until the two slots in the hous-
ing (A) and the bottom of the tank
(D) coincide, and pull the housing
of the device towards the above. To
close the device, follow the reverse
procedure.
3 Attach the center of the flex-
ible hose bracket (H) about 8 cm
from the edge of the sink to a clean
surface.
4 Hold the flexible hose (F) as it is
wrapped in the package as shown in
the figure and place it in the sink.
5 Connect the hose to the bracket
(H). The water flow switch (G) must
be between the edge of the sink and
the hose bracket (H).
6 Place Fin under the tap and
check that the tap water column
is running at the inlet of the
appliance. Hold Fin firmly and mark
the hose (F) to the point where it
can be inserted into the base holder
(D). Cut the rest of the hose.
7 Connect the hose to the base
holder (D).
8 Remove the filter of your tap
and place the filter (I) of the pack-
aging. If your tap has an external
thread, remove the inside of the
packaging filter and place it in the
shell of your own filter.