Inserting A New Uv Lamp; Replacement For Ap301 Uv Lamp - Boneco P300 Manual De Instrucciones

46
en

INSERTING A NEW UV LAMP

1. Remove the new UV lamp from the packaging.
2. Connect the clip of the new UV lamp to the cable
in the P300. Make sure the clip noticeably engag-
es.
3. Put the appliance back together by following the
steps in reverse order.
4. Connect the BONECO P300 to the power outlet.
5. Switch on the BONECO P300.
6. Press and hold the button for the performance
control for about 5 seconds until the UV warning
signal on the display goes out.

REPLACEMENT FOR AP301 UV LAMP

You can obtain a new AP301 UV lamp from your
BONECO specialist dealer or the BONECO online store
at www.shop.boneco.com.