Pro-Logix PL2140 Manual Del Usuario
Ocultar thumbs Ver también para PL2140:

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Read these instructions completely before using the SOLAR Battery Charger and save them for
future reference. Before using the SOLAR Battery Charger to charge a battery, read these
instructions and the instruction manual/safety information provided by the car, truck, boat or
equipment manufacturer. Following all manufacturers' instructions and safety procedures will
reduce the risk of accident.
Working around lead-acid batteries may be dangerous. Lead-acid batteries release explosive gases
during normal operation, charging and jump starting. Carefully read and follow these instructions for
safe use. Always follow the specific instructions in this manual and on the SOLAR Battery Charger
each time you use the SOLAR Battery Charger.
All lead-acid batteries (car, truck and boat) produce hydrogen gas which may violently explode in
the presence of fire or sparks. Do not smoke, use matches or a cigarette lighter while near
batteries. Do not handle the battery while wearing vinyl clothing because static electricity sparks
are generated when vinyl clothing is rubbed. Review all cautionary material on the SOLAR Battery
Charger and in the engine compartment.
Always wear eye protection, appropriate protective clothing and other safety equipment when
working near lead-acid batteries. Do not touch eyes while working on or around lead-acid batteries.
Always store clamps away from each other or common conductors. Improper storage of clamps
may cause the clamps to come in contact with each other, or a common conductor, which would
be hazardous if the charger was plugged into an AC outlet.
Use extreme care while working within the engine compartment, because moving parts may cause
severe injury. Read and follow all safety instructions published in the vehicle's Owner's Manual.
Battery Maintainer Model No. PL2140
Batteries being charged with the SOLAR Battery Charger unit likely contain liquid acids which are
hazardous if spilled.
WARNING
Failure to follow instructions may cause
damage or explosion, always shield eyes.
Read entire instruction manual before use.
WARNING
Operator's Manual
No. 141-212-000
Warning: This product contains chemicals, including
lead, known to the State of California to cause
cancer, birth defects and other reproductive harm.
Wash hands after handling.

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Pro-Logix PL2140

  • Página 10: Manual Del Usario

    Manual Del Usario PL2140 Cargador de batería INSTRUCCIONES IMPORTANTES DE SEGURIDAD-LEA ESTO PRIMERO...
  • Página 11: Precauciones Personales

    6. Para evitar descargas eléctricas, deseche el cargador contiene importantes instruccciones de seguridad y de baterías si el cable presenta defectos. operación para el modelo PL2140. 7. No opere el cargador se ha sufrido algún impactso 2. No exponga el cargador a la lluvia o nieve.
  • Página 12: Preparación

    PREPARACIÓN 4. Agregue agua destilada en cada celda hasta que la PREPARACIÓN PARA CARGAR LA BATERÍA batería de ácido alcance el nivel que especifica el 1. Cuando sea necesario sacar la batería del vehículo para fabricante de baterías. Esto ayuda a purgar el exceso de poder cargarla, desconecte primero el terminal de toma gas de las celdas.
  • Página 13: Carga De Una Batería Instalada En El Vehículo

    CARGA DE UNA BATERÍA INSTALADA EN EL VEHÍCULO ADVERTENCIA: LAS BATERIAS MARINAS (DE EMBARCACIONES) DEBEN SER RETIRADAS PARA CARGARLAS EN TIERRA. SI SE LAS CARGA A BORDO, SE NECESITA UN EQUIPO ESPECIALMENTE DISEÑADO PARA USO MARINO. ADVERTENCIA: SI SE PRODUCEN CHISPAS CERCA DE LA BATERIA SE PUEDE OCASIONAR UNA EXPLOSION. PARA EVITAR EL RIESGO DE CHISPAS CERCA DE LA BATERIA: 1.
  • Página 14 INSTRUCCIONES DE USO Configuraciones del cargador de baterías Nota: El cargador está diseñado para proteger contra fallas y cortocircuitos (consulte Características del Al realizar una adecuada conexión de la batería (consulte cargador de baterías). Si la batería a cargar tiene la Sección F o G, según corresponda), conecte el cable un voltaje de circuito abierto de menos de 1 V, el de alimentación de CA en la toma de CA.
  • Página 15: Proceso De Carga De Múltiples Fases

    LED de CARGA parpadeará. Esto indica que el tiempo de carga se extenderá mientras el cargador intenta reacondicionar la batería. FASES 5-7 PRO-LOGIX: MANTENIMIENTO IDEAL DE LA BATERÍA Una función clave de este cargador es cómo manejar una batería que permanece en el cargador luego de alcanzar la carga completa, tal como durante el almacenamiento de un vehículo de uso estacional.
  • Página 16 CHARACTERÍSTICAS ADICIONALES COMPATIBILIDAD CON MULTIPLES BATERÍA El cargador carga adecuadamente una amplia gama de tipos de baterías, incluidas baterías convencionales, libres de mantenimiento, AGM, de células de gel, con estructura en espiral y de ciclo profundo. TECNOLOGIA “Smart Clamp” (PINZA INTELIGENTE) El cargador enviará...
  • Página 17: Seleccionar El Tipo De Batería

    SELECCIONAR EL TIPO DE BATERÍA Para baterías convencionales y baterías libres de mantenimiento inundadas (húmedas), la selección ideal de tipo de batería es “STD”. Para baterías identificadas como construcción AGM, la selección ideal de tipo de batería es “AGM”. Para baterías identificadas como construcción por células de gel, la selección ideal de tipo de batería es “GEL”. Para la mayoría de las baterías con estructura en espiral, la selección ideal de tipo de batería es “AGM”.
  • Página 18: Para La Garantia O Atiende

    Para obtener respuestas acerca del uso, el servicio luego de la garantía o información acerca de la garantía y el servicio de éste u otros productos de Clore Automotive, póngase en contacto con el servicio técnico de Clore Automotive al 800.328.2921, 913.310.1050 o visite www.cloreautomotive.com. Modelo PL2140 141-212-000...

Tabla de contenido