Enerpac XLP Serie Hoja De Instrucciones

EIS 66.111-1 rev. A
Repair Parts Sheets for this product are available from the Enerpac web site at www.enerpac.com,
or from your nearest Authorized Enerpac Service Center or Enerpac Sales office.
Index:
English (GB) .................................................... 01 - 04
Français (FR) ................................................... 05 - 08
Deutsch (DE) ................................................... 09 - 12
Italiano (IT) ...................................................... 13 - 16
Español (ES) ................................................... 17 - 20
Nederlands (NL) .............................................. 21 - 24
XLP-Series presses can be set up to perform maintenance and
forming operations. Each press is delivered with cylinder, hose,
couplers and pump. The XLP-Series presses include a lower bed
lifting device. Optional is the V-block workpiece support to facilitate
the positioning of pipes and bars.
1.0 IMPORTANT RECEIVING INSTRUCTIONS
Visually inspect all components for shipping damage. Shipping
damage is not covered by warranty. If shipping damage is
found, notify carrier at once. The carrier is responsible for
all repair and replacement costs resulting from damage
in shipment.
SAFETY FIRST
10/2018
Instruction Sheet
XLP-Series 25 ton Workshop Presses
Pages Index:
Svenska (SE) .................................................. 25 - 28
Norsk (NO) ...................................................... 29 - 32
Suomi (FI) ....................................................... 33 - 36
Polska (PL) ...................................................... 37 - 40
Czech (CZ) ...................................................... 41 - 44
Pycckий (RU) .................................................. 45 - 48
Português (PT) ................................................ 49 - 52
2.0 SAFETY ISSUES
Read all instructions, warnings and cautions carefully. Follow all
safety precautions to avoid personal injury or property damage
during system operation. Enerpac cannot be responsible for
damage or injury resulting from unsafe product use, lack of
maintenance or incorrect product and/or system operation.
Contact Enerpac when in doubt as to the safety precautions
and operations. If you have never been trained on high-pressure
hydraulic safety, consult your distribution or service center for a
free Enerpac Hydraulic safety course. Failure to comply with the
following cautions and warnings could cause equipment damage
and personal injury.
A CAUTION is used to indicate correct operating or
maintenance procedures and practices to prevent
damage to, or destruction of equipment or other
property.
A WARNING indicates a potential danger that requires
correct procedures or practices to avoid personal
injury.
A DANGER is only used when your action or lack of
action may cause serious injury or even death.
WARNING: Wear proper personal protective gear
when operating hydraulic equipment.
WARNING: Stay clear of loads supported by
hydraulics. A cylinder, when used as a load lifting
device, should never be used as a load holding device.
After the load has been raised or lowered, it must
always be blocked mechanically.
a shim or spacer in any lifting or pressing application.
1
WARNING: USE ONLY RIGID PIECES TO
HOLD LOADS. Carefully select steel or
wood blocks that are capable of supporting
the load. Never use a hydraulic cylinder as
DANGER: To avoid personal injury keep
hands and feet away from cylinder and
workpiece during operation.
Pages
GB