After Using The Machine; Periods Of Inactivity; Using For The First Time; Maintenance And Care - Viper As430B Manual Del Usuario

ENGLISH

AFTER USING THE MACHINE

When work is done and before leaving the machine, completes the
following steps:
1. Follow the procedure as described in aforementioned section
about installing and unloading the brush/pad-holder, and take
off the brush/pad-holder.
2. Following the procedures described in related sections, drain
the water completely in Solution tank and recovery tank.
3. Complete the daily maintenance procedures (refer to the
section on maintenance).
4. Store the machine, including the brush/pad-holder and
squeegee, in a clean and dry place. The squeegee should be
lifted or taken off.

PERIODS OF INACTIVITY

If the machine is not to be used for more than 30 days, please treat
it in the following way:
1. Complete the necessary procedure that should be followed after the machine is used.
2. Disconnect the connector (9) connecting the battery and the machine.
3. In order not to damage the battery, and if the machine is not to be used for more than 3 months,
please charge the battery once every 3 months.

USING FOR THE FIRST TIME

After using for the first 9 hours, please check all parts to make sure nothing has become loose or
damaged during operation, and check if there are any visible damages or leakage.

MAINTENANCE AND CARE

The service life and the maximum operation safety of the machine are assured by proper and timely
maintenance and care.
The following table provides a general maintenance plan for the machine. The time intervals of
maintenance are determined to a large extent by the working conditions of the machine. These time
intervals should be formulated by the personnel responsible for the maintenance.
WARNING！
Only after the power of the machine is turned off and the connection between the
machine and the battery is disconnected should these procedures be performed.
Before proceeding with any of the maintenance procedures, please study carefully
the related safety sections.
All maintenance in the plan or all additional maintenance must be done by qualified personnel or
authorised service centers.
This manual only relates the simplest and the most common maintenance procedures.
For any maintenance procedures other than those stated in this table of planned maintenance, please
refer to the maintenance manual of the service center.
USER MANUAL
12
Figure 14