Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Solar Powered
Motion Sensor Light
Model 1802
FEATURES
INITIAL BATTERY CHARGE
The solar panel requires full, direct sunlight to
charge the battery. Clouds, rain, snow, and other
weather conditions may not allow the solar panel to
completely recharge the battery. Other obstructions
such as buildings or trees may block the sun as well.
When installing the solar panel, make sure it is
aimed as described below with a minimum amount
of obstructions. If possible, mount the panel facing
toward the southern sky.
PRIOR TO USE, the battery will require 3 to 7 days
of full sun to completely charge with the power
selection switch in the OFF position.
UNPACKING
WHERE TO MOUNT YOUR SOLAR
POWERED MOTION SENSOR LIGHT
Solar Light Fixture:
Solar Panel:
Tabla de contenido
loading

Resumen de contenidos para Heath Zenith HZ-1802-BK-A

  • Página 6: Luz Detectora De Movimiento Con Alimentación Solar

    DESEMPAQUE Luz detectora de movimiento con alimentación solar Modelo 1802 CARACTERÍSTICAS CARGA INICIAL DE LA BATERÍA El panel solar requiere luz de sol directa y total para cargar la batería. Condiciones climatológicas como nubes, lluvia, nieve y otros pueden evitar que DONDE MONTAR SU LÁMPARA el panel solar recargue completamente la batería.
  • Página 7: Instalación

    INSTALACIÓN Montaje de la lámpara solar: Montaje del panel solar: IMPORTANTE: Calafatee alrededor de la base y en la parte superior de las cabezas de los tornillos luego de la instalación. IMPORTANTE: Coloque el selector de alimentación en la posición OFF y deje que la batería se cargue de 3 a 7 días de mucho sol antes de la prueba.
  • Página 8: Regulación Final Y Arranque

    REGULACIÓN FINAL Y ARRANQUE Regulación de los proyectores: Selector de alimentación: Regulación del Área de Cobertura: Regulación del detector de movimiento: Nota: Sensibilidad Mínima Sensibilidad Máxima 206153-01...
  • Página 9: Advertencias Generales De Seguridad Y Eléctricas

    ADVERTENCIAS GENERALES DE ALMACENAMIENTO SEGURIDAD Y ELÉCTRICAS CAMBIO DE LA BATERÍA PUNTOS QUE SE DEBEN RECORDAR IMPORTANTE: La batería de plomo-ácido sellada debe ser reciclada o desechada correctamente. ADVERTENCIA: Si usa esta lámpara mientras está acoplada al panel solar, use solamente baterías AA recargables de Ni-MH y 1,2 voltios.
  • Página 10: Guía De Análisis De Averías

    GUÍA DE ANÁLISIS DE AVERÍAS SÍNTOMA POSIBLE CAUSA SOLUCIÓN SERVICIO TÉCNICO Favor de llamar al 1-800-858-8501 (sólo para hablar en inglés) para pedir ayuda antes de devolver el producto a la tienda. www.hzsupport.com 1-800-858-8501 No hay piezas de servicio disponibles para este producto. Por favor guarde su recibo de venta fechado;...

Tabla de contenido