3M 28659 Manual De Instrucciones

3
MATCH AND FINISH SANDER INSTRUCTIONS MANUAL
101 mm depth x 101 mm Diameter (4 inch depth x 4 inch diameter)
3 500 RPM
Please read, understand and follow all safety information contained in these instructions prior to the use of this tool.
Retain these instructions for future reference.
This pneumatic tool is intended for use in industrial locations, and used only by skilled, trained professionals in accordance with the instructions in this manual. This
pneumatic tool is designed to be used with appropriate abrasive for sanding metals, wood, stone, plastics and other materials. It should only be used for such sanding
applications and within its marked capacity and ratings. Only accessories specifically recommended by 3M should be used with this tool. Use in any other manner or
with other accessories could lead to unsafe operating conditions.
Do not operate tool in water or in an excessively wet application.
Do not use abrasive products that have a Max RPM less than the RPM rating marked on the tool.
Marking
90 PSIG / 6.2 BAR MAX
3,500 r/min.
Use accessories rated at tool RPM or higher
Prolonged vibration may cause injury
Indicates a potentially hazardous situation which, if not avoided, may result in death or serious injury and/or property damage.
WARNING:
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury and/or property damage.
Read the Material Safety
Data Sheets (MSDS)
before using any materials.
MSDS
Contact the suppliers of the
workpiece materials and
abrasive materials for copies
of the MSDS if one is not
readily available.
Important Safety Information
Summary of device labels containing safety information
Description
WARNING: Refer to Instruction Manual
WARNING: Wear eye protection
WARNING: Wear hearing protection
Direction of Rotation
Maximum Pneumatic Inlet Pressure
Maximum Rotational Speed
Accessories Safety Note
Vibration Safety Note
Explanation of Signal Word Consequences
WARNING!
Exposure to DUST generated from
workpiece and/or abrasive materials
can result in lung damage and/or other
physical injury.
Use dust capture or local exhaust as
stated in the MSDS. Wear government-
approved respiratory protection and eye
and skin protection.
Failure to follow this warning can
result in serious lung damage and/or
physical injury.
Intended Use
2
Original Instructions