3M 28366 Manual De Instrucciones

FILE BELT SANDER INSTRUCTION MANUAL
1 / - 3 / in. x 18-24 in. (3-19 mm x 457-610 mm)
8 4
22,000 RPM, 4990 SFPM (1521 smm)
Please read, understand and follow all safety information contained in these instructions prior to the use of this tool. Retain these instructions for future reference.
This pneumatic tool is intended for use in industrial locations, and used only by skilled, trained professionals in accordance with the instructions in this manual.
This pneumatic tool is designed to be used with a contact arm and appropriate abrasive belts for sanding metals, wood, stone, plastics and other materials. It
should only be used for such sanding applications and within marked capacity and ratings. Only accessories specifically recommended by 3M should be used with
this tool. Use in any other manner or with other accessories could lead to unsafe operating conditions.
Do not operate tool in water or in an excessively wet application.
WARNING:
CAUTION:
To reduce the risks associated with impact from abrasive product, or tool breakup, sharp edges, hazardous pressure, rupture, vibration and noise:
• Read, understand and follow the safety information contained in these instructions prior to the use of this tool. Retain these instructions for future refer-
ence.
• Only personnel who are properly trained should be allowed to service this tool.
• Practice safety requirements. Work alert, have proper attire, and do not operate tools under the influence of alcohol or drugs.
• Operators and other personnel must always wear protection for eyes, ears, and respiratory protection when in the work area or while operating this
product. Follow your employer's safety policy for PPE's and/or ANSI Z87.1 or local/national standards for eyewear and other personal protective equipment
requirements.
• Wear protective apparel, taking into consideration the type of work being done.
• Never exceed marked maximum input pressure (90psi / .62Mpa / 6.2Bars).
• Proper eye protection must be worn at all times.
• Tool shall not be operated in the presence of bystanders.
• If you notice any abnormal noise or vibration when operating the tool, immediately discontinue its use and inspect for worn or damaged components.
Correct or replace the suspect component. If abnormal noise or vibration still exists, return the tool to 3M for repair or replacement. Refer to warranty
instructions.
• Never operate this tool without all safety features in place and in proper working order.
• Never over-ride or disable the safety features of the start-stop control such that it is in the on position.
• Make sure the tool is disconnected from its air source before servicing, inspecting, maintaining, cleaning, and before changing abrasive product.
• Prior to use, inspect abrasive product and accessories for possible damage. If damaged, replace with new abrasive product and accessories available from
3M.
• Only use accessories supplied or recommended by 3M.
• Never allow this tool to be used by children or other untrained people.
• Do not leave an unattended tool connected to air source.
• Use only with mounting hardware recommended by 3M; check with 3M for mounting hardware requirements.
• Prior to use, ensure guard is oriented to protect the operator from flying fragments and is properly secured.
• If the tool is jammed, shut off the tool, disconnect the air hose and ease it free. Ensure the abrasive product is correctly secured.
• Never operate this tool without all guards and safety features in place and in proper working order.
3M 1 / in. to 3 / in. File Belt Sander
8 4
Important Safety Information
Explanation of Signal Word Consequences
Indicates a potentially hazardous situation which, if not avoided, may result in death or serious injury
and/or property damage.
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate
injury and/or property damage.
Intended Use
WARNING
1
Original Instructions
Revision 022514