Product Introduction; Installation - Roborock H5 Manual Del Usuario

Product Introduction

A
Main Unit
A1
—Power
• Press: Start/Stop
Rear Filter
A1-1—
Change Mode
A1-2—
Eco Mode
Standard Mode
Max Mode
Charging Port
A1-3—
Battery Level Indicator Light
A1-4—
• Full: Three steady lights
• High: Two steady lights
• Medium: One steady light
• Low: One flashing light
A1-5— Multi-Cyclone Assembly
A1-6—Dustbin
Dustbin Opener
A1-7—
Power Supply
A2
Motorized Mini-Brush
A3
2-in-1 Cleaning Head
A4
Multi-Surface Brush
A5
Disposable Dust Bag
A6
Dust Bag Holder
A7
Charging Dock
A8
Baton
A9

Installation

B
Cleaning Heads
B1
Disposable Dust Bag (Optional)
B2
B2-1—Press the dustbin opener to open
the bottom cover of the dustbin and
rotate to remove the multi-cyclone
assembly.
B2-2—Insert the disposable dust bag along
the slot of the dust bag holder.
Ensure it is properly installed.
B2-3—Insert the dust bag holder. Ensure it
is properly installed.
B2-4—Attach the bottom cover of the
dustbin into place.
Notes:
• To ensure optimal vacuuming performance, it is
recommended to replace the dust bag regularly or when it is
full.
• The dust bag features a one-off seal which will securely seal
the bag on removal. This design effectively prevents dust
leakage.
• Please do not pull out the seal unless you are discarding the
dust bag. A pulled seal cannot be restored.
• After replacing the disposable dust bag, please stow the
removed multi-cyclone assembly properly.
08
Charging Dock (Optional)
B3
*It is recommended that you let specialists install the
charging dock. Use protective clothing, safety goggles, and
other protective equipment when necessary.
B3-1—To attach the positioning sticker：
Attach the positioning sticker onto
the wall. Ensure that the edges are
parallel to the ground and the bottom
is approximately 105 cm (3.5 ft) above
the ground.
B3-2—Diameter of drill bit: 6 mm (0.24 in)
B3-3—About 105 cm (3.5 ft)
B3-4—To install the charging dock:
Use an electric tool with an 6-mm
(0.24 in) drill bit to create holes that
align with the positioning holes on
the sticker. Securely fix the charging
dock using the provided expansion
tubes and screws.
Notes:
• The dock should be fixed in a cool and dry area near a power
source.
• The dock is an optional accessory and can be installed
according to actual needs.
• Prior to installation, ensure that there are no wires or pipes
running through the wall where the dock will be located.