Basic Parameters - Roborock H5 Manual Del Usuario

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Cleaning Head Rollers

Inspect and clean the cleaning head rollers

periodically to ensure product performance.

Before removing a roller, ensure that the

cleaning head has been separated from the

main unit to avoid causing injuries.

Notes:

• The roller part of a cleaning head must be removed for

separate cleaning.

• There are electrical components in the motorized mini-brush

and multi-surface brush and bearings in the multi-surface

brush roller. Do not rinse them.

Multi-Surface Brush

D4-1—Place the multi-surface brush in the

direction shown in the diagram. Use

a coin-like object to rotate the lock

catch counterclockwise to unlock it.

D4-2—Pull out the lock catch and roller

brush from the cleaning head.

D4-3—Clean the fibers and hair wrapped

around the roller and the lock catch.

D4-4—After cleaning, reinstall the lock catch

into the roller.

D4-5—Rotate the lock catch clockwise until

you hear it lock with a click.

Motorized Mini-Brush

D5-1—Rotate the lock catch

counterclockwise to the unlock

position to remove the lock catch.

D5-2—Take out the roller from the

motorized mini-brush.

D5-3—Clean and wash the roller.

D5-4—Place the roller vertically and dry

it for at least 24 hours to ensure

thorough drying.

D5-5—When the roller is completely dry,

reinstall the roller and lock catch

back in place.

D5-6—Rotate the lock catch clockwise to

the lock position, and ensure that the

roller is properly installed.