Maintenance; General Maintenance - Ryobi Pcl601 Manual Del Operador

Devices enabled for BLUETOOTH
the signal and set to search/scan in order to pair with
the product.
Select "RYOBI LINK STEREO" from your device's list of
available BLUETOOTH
stereo. No password or PIN is required for connection.
When the device has successfully paired with the product,
the "bt" will stop flashing and turn solid.
NOTE: When a device is paired to the product , informa-
tion for connecting to the device is saved in the product's
memory.
WARNING:
Always remove the battery pack from the product and
disconnect from the power supply when you are assem-
bling parts, cleaning, or when not in use. Removing
battery pack or unplugging extension cord will prevent
accidental starting that could cause serious personal
injury.
WARNING:
When servicing, use only identical replacement parts.
Use of any other part could create a hazard or cause
product damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
LINK STORAGE
See Figure 6, page 13.
Remove the battery and store in a secure location out of the
reach of children.
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
must be in range of
®
® signals to pair the device and the

MAINTENANCE

NOTE: ILLUSTRATIONS START ON PAGE 11
OPERATION
When streaming audio from a BLUETOOTH
device, press the left or right button to go to the previous
or next track. Briefly press and release the PLAY/PAUSE
button to cycle between pausing and playing the audio.
NOTE: These controls may not be supported by the
BLUETOOTH
To disconnect the BLUETOOTH
and hold the PLAY/PAUSE button. When the device is
disconnected, "bt" will begin flashing on the LCD display
and the product begins searching for a BLUETOOTH
signal.
WARNING:
Hold the product close to your body. Keep your knees
bent and lift with your legs, not your back. Ignoring these
precautions can result in back injury.
LINK tool box storage:
Carefully lift the product and position the product with
the face plate down onto two raised octagonal patterns
on the LINK tool box and click in place.
Push the LINK release button on the side of the product
to remove.
LINK wall rail storage:
Carefully lift the product and position the product with the
face plate up onto two of the raised octagonal patterns
on the LINK wall rail.
IMPORTANT! To ensure the product is seated properly,
check that the holes on the face plate of the product
are lined up with the corresponding holes in the LINK
wall rail.
Push the LINK release button and lift to remove.
Refer to the LINK wall rails operator's manual for further
instructions.
9 - English
device and/or application you are using.
®
enabled device, press
®
enabled
®
®