Operation - Ryobi Pcl601 Manual Del Operador

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove the battery pack from the product and
disconnect from the power supply when you are assem-
bling parts, cleaning, or when not in use. Removing
battery pack or unplugging extension cord will prevent
accidental starting that could cause serious personal
injury.
WARNING:
This radio is capable of producing sound levels that can
be dangerous to long-term hearing. Listening to music
at high volume for any period of time can cause noise-
induced hearing loss. The higher the volume, the less time
required before your hearing could be affected.
NOTICE:
Always refer to the manual for any device recommended
for use as an attachment or accessory. Proper use of any
device, when attached to the radio, is the sole respon-
sibility of the operator. Improper use may damage the
device or the product.
APPLICATIONS
You may use this product for the following purposes:
Listening to FM radio and BLUETOOTH
charging USB-capable devices.
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always be in the OFF posi-
tion when not in use or carrying at your side.
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 10.
To install:
Insert the battery pack.
Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
product before beginning operation.
To remove:
Depress the latches on each side of the battery pack.

OPERATION

For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
INSTALLING/REMOVING POWER CORD
See Figure 2, page 10.
LCD DISPLAY
See Figure 3, page 11.
NOTE: The illustrations of the LCD display shown in this
manual are only examples of the frequencies you may see
on your product and are not the exact frequencies that you
may choose to listen to.
When the product is not connected to a power supply, the
LCD display will remain off. If the product is connected to
a power supply and in the ON position, LEDs will light the
display. You can view the frequency and settings in use on
the LCD display.
NOTE: Always disconnect battery packs after use to prevent
draining the battery pack.
TURNING THE PRODUCT ON/OFF
See Figure 3, page 11.
Press the power knob to turn the product ON or OFF.
NOTE: You may need to keep the power knob pressed for
up to 3 seconds before the product will start.
To help preserve battery power, the product will automatically
turn off after 30 minutes. To restart the product, you must
audio devices;
®
press the power knob on the product.
ADJUSTING THE VOLUME
See Figure 3, page 11.
When the product is turned ON, it will return to the default
volume setting.
NOTE: If the 18V battery is removed from the product or has
no charge, the product will return to the default volume setting.
NOTICE:
Do not use the product at maximum volume for an
extended period of time with the bass and treble at maxi-
mum levels. It could cause damage to the speakers and/
or amplifiers in your product.
7 - English
Push the ON/OFF button to turn the product OFF.
Insert the female end of the power cord into the product
as shown.
Connect the male end of the power cord to the power
source.
Make sure the power cord is secured before beginning
operation.
To increase the volume: turn the power knob clockwise.
To decrease the volume: turn the power knob counter-
clockwise.