Mode Selection - Ryobi Pcl601 Manual Del Operador

MODE SELECTION

See Figure 3, page 11.
Press the MODE button to cycle through available modes.
FM mode
BLUETOOTH Listening to audio from BLUETOOTH
®
capable devices.
The product will return to the last mode that was used when
properly turned off. In the event all power is lost to the prod-
uct, it will default to the FM mode, unless BLUETOOTH
used when last properly turned off.
THE EQUALIZER FUNCTION
There are four equalizer settings to choose from:
BASS+ enhances the low notes and makes the bass
more powerful.
TREBLE+ enhances the high notes and makes speech
clearer.
HI-FI refers to a high-quality reproduction of sound.
VOICE enhances podcast listening.
To change equalizer settings:
Hold the MODE button.
Tap the TUNE/SEEK forward or backward arrow buttons
to cycle through the settings.
FM TUNING
See Figure 3, page 11.
The TUNE/SEEK left and right arrow buttons are used to
tune to the desired radio frequency. The selected frequency
is displayed on the LCD.
Briefly press either button (not press and hold) to tune
one frequency step at a time.
To SEEK, press and hold desired arrow button for 1 sec-
ond to tune to the next frequency with clear reception.
STORING A PRESET IN MEMORY
See Figure 3, page 11.
The memory feature saves up to 10 frequencies as presets
in the product's memory.
To store a frequency in memory:
Tune to the frequency you want to save.
Press and hold the PRESET button. A memory location
number will blink on and off.
Press the TUNE/SEEK button to select a memory loca-
tion.
Press the PRESET button to store the frequency in the
selected memory location.
OPERATION
To recall a preset frequency:
Press the PRESET button and quickly release to cycle
through stored frequencies.
CONNECTING TO THE SPEAKER SYSTEM
See Figure 3, page 11.
®
The INTERCONNECT button works two ways:
Press the INTERCONNECT button. Once the product is
connected to BLUETOOTH
will show on the LCD display. Compatible speakers will
was
®
be able to sync with the product.
Press the INTERCONNECT button when the product is
not connected to BLUETOOTH
show in the LCD display. The product will begin searching
for compatible speakers.
USB DEDICATED CHARGING PORT
See Figure 4, page 11.
The USB dedicated charging port provides charging power
of up to 2 Amps for your cell phone, tablet, MP player or
other USB devices.
NOTICE:
Attempting to charge devices rated more than 2 Amps
could damage the USB dedicated charging port and/or
the device.
Connect one end of a USB cable (not provided) to your
USB device.
Connect the other end of the USB cable (not provided)
to the USB dedicated charging port to begin charging
the device.
NOTE: The USB dedicated charging port provides power
only; it does not provide any communication capabilities.
When the product is operating on battery power, the
USB dedicated charging port will continue to function
for approximately 1 hour after turning the product OFF. If
the product remains inactive after this time, charging will
stop. Turn the product on to resume operation.
USING A BLUETOOTH
(NOT INCLUDED) WITH THE STEREO
See Figure 5, page 11.
When the product is switched to BLUETOOTH
the product will search for a BLUETOOTH
"bt" flashes in the LCD display.
NOTE: The product will automatically attempt to connect
to the last device it was paired to. If a connection cannot
be established within five seconds, the product will make
itself available to other BLUETOOTH
8 - English
® or in the FM mode "Primary"
and "Secondary" will
®
ENABLED DEVICE
®
®
signal and
®
enabled devices.
®
mode,