WERKU WK401450 Manual De Instrucciones página 4

ENG ORIGINAL INSTRUCTIONS
PRODUCT DESCRIPTION.
This vacuum cleaner has been designed to carry
out jobs of dry or wet vacuum cleaning, as well
as compatible extraction (if applicable, synchro-
nously) with electric and pneumatic tools. Refer to
this plan to familiarize yourself with this vacuum
cleaner before use.
E
K
L
H
J
N
I
O
T
A. Floor brush
B. Telescopic tube
C. Hose connection
D. Hose
E. Upper suction (solids)
F. Handle
G. Switch
H. Power regulator
I. Frontal suction (liquids)
J. Blower connection
K. Cleaning button
L. Push bar
M. Power cable
N. Clamping strap
O. Tank
P. Small nozzle
Q. Round nozzle
R. Synchronization plug
S. Mobile plug
T. Transport wheels
USE INSTRUCTIONS.
Before starting up this vacuum cleaner, we recom-
mend that you carefully read all the instructions as
indicated. Please respect all regulations regarding
the prevention of accidents, health and safety di-
rectives, laws and applicable restrictions for work
places. This vacuum cleaner must only be used
by persons who have been instructed in its use
and only for the purposes for which it has been
C
designed.
M
POWER SUPPLY.
F
Make sure the power supply is adapted to the re-
quirements shown on the information panel of this
vacuum cleaner (1). Using the motor at low volta-
ge will make it operate slowly. This will reduce per-
formance and may cause the motor to overheat.
D EXTENSION CORD.
If the working area is at some distance from the
R
power supply, use an extension cord of enough
G
diameter and quality.
Q
OPERATION MODES.
1. Solids suction:. Place the hose in the upper suc-
P
tion port (2). Place the movable plug in the front
S
suction port and turn it clockwise (3). 2. Liquids
suction:. Place the hose in the front suction inlet
(4). Put the plug in the upper suction inlet and turn
A
it clockwise (5). 3. Air blower:. Place the hose on
the blower connection (6). Put the cap on the top
or front intake and turn it clockwise (3, 5).
ON/OFF.
Connect the power cord to a regulatory, grounded
installation. To switch this vacuum cleaner on or
off, use the switch (7).
POWER REGULATION.
To regulate the power, use the knob (8).
SYNCHRONIZED AUXILIARY SOCKET.
This vacuum cleaner has a socket to be connec-
ted synchronously with a power tool, so that this
vacuum cleaner turns on and off when turning
the power tool on and off (9). To do this, place the
switch of this vacuum cleaner in the position with
two horizontal lines (10) and insert the power tool
plug into the vacuum cleaner socket. Synchroni-
zation between the vacuum cleaner and the power
tool will occur with a delay of about 5-10 seconds.
If the synchronization does not work, this is due to
4
English