NETGEAR EX3110 Quick Start Guide página 4

Connect the Extender to Your
WiFi Network
You can connect with WPS or you can use the NETGEAR installation
assistant from a web browser.
Connect With WPS
Wi-Fi Protected Setup (WPS) lets you join a secure WiFi network
without typing the network name and password.
NOTE: WPS does not support WEP network security.
If you are using WEP security, follow the instructions in
Connect With the NETGEAR Installation Assistant on the
other side of this quick start guide.
Press the WPS button on the extender until the WPS LED blinks.
1.
2. Within two minutes, press the WPS button on your router or
access point.
When the extender connects to your existing WiFi network,
the WPS LED on the extender lights solid green and the
Router LED lights.
If the Router LED does not light, try again. If it still does not
light, see Connect With the NETGEAR Installation Assistant
on the other side of this quick start guide.
4