Thinklabs One Manual Del Usuario página 10

i
See "About the Audio Filters in your One" later in these instructions, for an explanation of filters.
f
0 Hz
Low High
0 10
+
Hz Scale
shows pitch range
of filter selection
NOTE: The filters on your
One might be different
from the diagram shown
here.
8
3. Filter Selection and Display
Select Filter - a . Hold
b . Release key when LEDs change.
c . Repeat to cycle through filter choices.
Set two "Favorite Filters" - set two favorite filters, then
alternate easily between the two selections:
1. Select 1st Favorite - steps a through c above.
2. Click (do not hold)
3. Select 2nd Favorite - steps a through c again.
4. Click (do not hold)
5. To use any other filter, simpy do steps a through c anytime
and the Favorite you're currently using will be changed.
0 Hz
Hold
f key
0 Hz
Favorite 1
Hold
f key
Hold
0 Hz
0
f key
f
key for ~2 seconds.
f
key.
f
key to alternate between Favorites.
Click f key
Hold
Hold
f key f key
0 Hz
0 Hz
Hold Hold
f key f key
Click f key
Hz
0
0 Hz
Hold
f key
0 Hz
Favorite 2
Hold
f key
Hold
Hz 0 Hz
f key