Installing And Connecting The Wires For The New Xg 3D Diaphragm Unit; Installing The Outer Ring And Headrest; Safety Checks; Attaching Cover Parts - Sirona Orthophos Xg 3Dready Manual De Instrucciones

Sirona Dental Systems GmbH
Converting Instructions "ORTHOPHOS XG 3D
63 14 541 D3352
D3352.092.08.05.02 079.2012
ready
to ORTHOPHOS XG 3D" ORTHOPHOS XG 3D
6.15
Installing and connecting the wires for the new
XG 3D diaphragm unit
1. NOTICE! Ensure that the new diaphragm unit is securely hooked into

Installing and connecting the wires for the new XG 3D diaphragm unit

the tube assembly with the bottom two flaps.
Hook the new diaphragm unit with the bottom two flaps into the brass
rings (B) on the tube assembly and fix them again with the screw (A).
2. Plug cables L20 and L21 into connectors X203 (L20), X302 (L21) and
X303 (L21) on board DX61.
3. Plug cables L11 and L12 into connectors X501 (L11) and X101 (L12)
on board DX6.
B
6.16

Installing the outer ring and headrest

Installing the outer ring and headrest
1. Attach the outer ring incl. swim ring [ → 19].
2. Assemble the headrest [ → 19].
6.17

Safety checks

Safety checks Safety checks
Once the installation/conversion work is complete, the protective ground
conductor and unit leakage current must be tested (see Service Manual,
"Maintenance" chapter).
6.18

Attaching cover parts

Attaching cover parts
IMPORTANT! Instead of the old slide cover, the "slide cover, compl.",
install the new "3D slide cover, compl." (included in the scope of delivery).
➢ Install the cover parts [ → 16].
6 Mechanical conversion
ready
6.15 Installing and connecting
37