Mounting The Wheels To The Legs; Installing The Bottom Shelf; Securing The Lid Stopper; Assembling The Lid Handle - Pit Boss Pb700Fb Montaje Y Operación

2. MOUNTING THE WHEELS TO THE LEGS

Parts Required:
2 x Metal Wheel (#7)
2 x Washer (#B)
Nut (#C)
2 x
Installation:
• Slide a metal wheel onto each leg with wheel axle. Secure using a
washer and a nut. Spin each wheel to ensure the wheels turn freely.

3. INSTALLING THE BOTTOM SHELF

Parts Required:
Bottom Shelf (#14)
1 x
Screw (#A)
4 x
4 x Locking Washer (#D)
4 x Washer (#E)
Installation:
• From underneath, secure the bottom shelf to all each leg using a
screw, locking washer, and washer. Ensure the flat surface of the shelf
is facing up.
• Once the shelf is secure, carefully lift the grill into an upright position.

4. SECURING THE LID STOPPER

Parts Required:
1 x Lid Stopper (#3)
Installation:
• Secure the lid stopper onto the top of the main barrel using the pre-
installed screw on the top of the main barrel.

5. ASSEMBLING THE LID HANDLE

Parts Required:
1 x Lid Handle (#9)
Bezel (#8)
2 x
Installation:
• Remove the pre-installed screws from the lid handle. From inside the
barrel lid, insert one screw to protrude to the outside. Add a bezel on the
screw, then hand-tighten the screw (from the inside) into the lid handle.
• Repeat same installation for other end of lid handle.
8
2
3
4
5