Maintenance Table; Troubleshooting - Stiga Mpst 84 Li 48 V1/V2 Manual De Instrucciones

14. MAINTENANCE TABLE

Use the boxes at the side to note the date or number of operating
hours when the intervention was performed.
Intervention
Check all fasteners
Tyre pressure check
Safety checks/check controls
Check the drive release lever
Assembly / Check of the
protections at the exit
Charging the battery
General cleaning and inspection
Checking for any damage to the
machine. If necessary, contact
the authorised service centre.
Cutting means positioning
and sharpening check
Replacing cutting means
General lubrication
* This operation must be carried out by your Dealer or an Authorised Service Centre.
** General lubrication of all joints should also be carried out whenever
the machine is to be left unused for a long period

15. TROUBLESHOOTING

PROBLEM
1. The machine will
not switch on.
2. Irregular cutting
Frequency
(hours)
Before each use
Before each use
Before each use
Before each use
Before each use
Before each use
After each use
Before storage
After each use
After each use
25
100
25
Cause
Low battery.
Cutting means
sharpening is reduced.
High forward speed in
relation to the height
of the grass to be cut.
Cutting means assembly
full of grass.
EN - 32
Performed (Date or Time)
Remedy
Charge the battery (par. 8.2.2).
Contact an Authorised Service Centre
Authorized.
Reduce forward speed
and/or Increase the cutting height:
Wait for the grass to dry.
Clean the cutting means assembly.
Notes
para. 7.1.3
par. 7.2
para. 6.3
para. 5.5
par. 8.2
para. 8.4
*
*
par. 8.5 **