Delta MultiChoice 17 Serie El Manual Del Propietario
Ocultar thumbs Ver también para MultiChoice 17 Serie:
Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Write purchased model number here.
Table of Contents:
For additional replacement parts, visit www.deltafaucet.com
THIS VALVE MEETS OR EXCEEDS THE
FOLLOWING STANDARDS: ASME A112.18.1/
CSA B125.1 and ASSE 1016 (Type -P- or -T-).
CAUTION: This system/device must be set by the
installer to ensure safe, maximum temperature.
Any change in the setting may raise the discharge
temperature above the limit considered safe and
may lead to hot water burns.
NOTICE TO INSTALLER: CAUTION!–As the
installer of this valve, it is your responsibility
to properly INSTALL and ADJUST this valve
per the instructions given. This valve does
not automatically adjust for inlet temperature
changes, therefore, someone must make the
necessary Rotational Limit Stop adjustments
at the time of installation and further adjustments
may be necessary due to seasonal water
temperature change. YOU MUST inform the
owner/user of this requirement by following
the instructions. If you or the owner/user are
unsure how to properly make these adjustments
please refer to page 7 and if still uncertain, call
us at 1-800-345-DELTA.
your name, company name and the date you
12/11/2015
MultiChoice
Installation Instructions
Owners Manual
17 Series
You May Need
adjusted the Rotational Limit Stop to the caution
label provided and apply or attach the label to
the back side of the closest cabinet door and the
warning label to the water heater. Leave this
Instruction Sheet for the owner's/user's
reference.
WARNING: This pressure balanced or
thermostatic bath valve is designed
to minimize the effects of outlet water
temperature changes due to inlet pressure
changes, commonly caused by dishwashers,
washing machines, toilets and the like. It may
not provide protection from hot water burns
when there is a failure of other temperature
controlling devices elsewhere in the
plumbing system, if the rotational limit stop
is not properly set or if the hot water
temperature is changed after the settings are
made or if the water inlet changes
due to seasonal changes.
WARNING: Do not install a shut-off device on
either outlet of this valve. When this type of
device shuts off the water ow, it can defeat
the ability of the valve to balance the hot and
cold water pressures.
1
®
Valve Trim
76652 Rev. F
Tabla de contenido
loading

Resumen de contenidos para Delta MultiChoice 17 Serie

  • Página 9: Usted Puede Necesitar

    érase al Página 7 ADVERTENCIA: No instale un aparato de corte 1-800-345-DELTA. o cierre en cualquiera de las tomas de esta válvula. Cuando este tipo de aparato cierra el puede agregarle a la etiqueta de aviso...
  • Página 10: Garantía Limitada De Por Vida De La Llave Y Su Acabado

    Las piezas de repuesto se pueden obtener llamando al al número que le corresponda anteriormente incluido. escribiendo a: Garantia Limitada de Delta HDF garantizadas al dueño original de estar libres de defectos en materiales y en la mano de obra por un se ve en el recibo de compra.
  • Página 11: Instalación Del Cartucho

    Instalación Instalación del Cartucho Cierre los suministros de agua. cubierta (1), la tuerca tapa (2) y la tapa de correctamente colocados dentro de los delgada, puede quitar el protector (4) de yeso retenedor (2) del adaptador. antes de instalar el cartucho. Instalación de Espalda a Espalda Instalación Normal Instalación...
  • Página 12 Instalación Instalación de la Cabeza de la Regadera y el Surtidor de la Bañera PARA LAS INSTALACIONES DE LAS CABEZAS DE REGADERA: Conecte la toma de salida de agua superior (1) al brazo de la regadera (2) con los del brazo de la regadera, introduzca el extremo que va hacia la pared del brazo de la regadera dentro del regadera.
  • Página 13 Instalación Instalación de la Cabeza de la Regadera y el Surtidor de la Bañera PARA LA INSTALACIóN DEL SURTIDOR DE LA BAÑERA: instalación suministradas con su surtidor. No conecte los surtidores para las instalaciones en las Instalación deslizable nominal. Importante: Si es necesario cortar el tubo de cobre, el extremo debe biselarse que quede libre de rebabas para prevenir cortar o el surtidor sobre el tubo de cobre al ras con la...
  • Página 14: Instalación Final

    Instalación Instalación Final La instalación de la roseta para los modelos T17053, T17253, T17453, T17067, T17267 y T17467. como un separador para estabilizar la manga, debe quedar apoyado en la usando los 2 tornillos suministrados (4). No apriete demasiado los tornillos de la roseta. Si está...
  • Página 15 Instalación Instalación y Ajuste del Tope que Limita la Rotación Instalación y Ajuste del Tope que Limita la Rotación Coloque la perilla para el control de la temperatura (1) en la manija para controlar el volumen y gire a la posición mixta (si se suministros de agua;...
  • Página 16: Limpieza Y Cuidado De Su Llave

    Limpieza y Cuidado de su Llave ¡ADVERTENCIA! No se puede usar Tenga cuidado al ir a limpiar este producto. Aunque su acabado es sumamente durable, SCRUBBING BUBBLES® BATHROOM puede ser afectado por agentes de limpieza CLEANER o LYSOL® BASIN TUB AND TILE CLEANER en las manijas transparentes.
  • Página 27 Notes / Notas / Notes 76652 Rev. F...
  • Página 28 55 E. 111th Street 76652 Rev. F...

Este manual también es adecuado para:

Multichoice t17453-h2o

Tabla de contenido