Forney EASY WELD 140 FC-i Guia De Inicio Rapido

CAT# 261
QUICK START GUIDE
140 FC-i FLUX-CORED WELDER
(DESIGNED FOR MILD STEEL WELDING ONLY)
1.
Read user manual
2.
Install wire spool
0.030" (0.8mm) diameter
8" (200mm)
wire spool
4" (100mm)
wire spool
3.
Set drive roll
Face the side marked 0.030" away from the machine
0.030"
5.
Connect to Input Power
120VAC, 20A
outlet, 30A breaker
recommended
• Generator OK with continuous output > 4,000 W
• Extension cord: #12 AWG or larger; 25' (8m) or shorter
7.
Adjust wire feed speed (
See chart on welder for correct settings
FIND FLUX-CORED WELDING TIPS AT WWW.ASKFORNEY.COM
MIG Gun
) and voltage ( )
QUESTIONS OR TROUBLE? Contact Forney Industries at 1-800-521-6038
customerservice@forneyind.com • askforney.com • forneyind.com
4.
Feed wire and set pressure
For proper tension align the tops of the screw and nut together
6.
Remove consumables and depress trigger until wire
comes out. Replace consumables.
8.
With contact tip 1/4" from metal, depress trigger
completely to initiate arc
Ground
Clamp
EN_v1-1