Heath Zenith SL-6155 Serie Manual De Instalación

Decorative Wireless Doorbell
This package includes (Style of push button and chime may vary from illus-
tration):
• Wireless chime
• Wireless push button w/battery
• Hardware pack
You'll need to buy 3 "D" alkaline batteries for the chime. In typical use,
alkaline batteries will last up to three years.
3.
Test range. Temporarily position chime and push button where you want
them mounted. Press push button to verify chime and push button work
properly. If chime does not sound, see Troubleshooting.
© 2003 DESA Specialty Products™
SL-6155 and SL-6250 Series
1.
Install alkaline type A23 12 volt push button bat-
tery. Remove back of case by pushing in tab on
bottom with a small screwdriver. Make sure battery
is oriented properly (see page 3).
4.
Mount push button and chime.
Use either screws or double sided tape to mount
push button.
To mount with screws, remove back of case by push-
ing tab on bottom with a small screwdriver.
Attach back of case to door jamb or wall. Snap front
of button on.
When attaching push button using double sided tape,
make sure the surface of the door jamb or wall is clean.
See page 2 for help removing the
chime case.
2.
Install 3 alkaline "D" batteries.
Make sure batteries are oriented
properly.
598-1000-05