Heath Zenith 8421 Manual De Instrucciones

Motion Sensor Security
Light
Model
8421
Features
• LED motion light.
• Automatically operates at night only.
Package Contents
• Security Light (see model above)
• Short Bracket Screws (2x)
• Long Fixture Screws (2x)
• Decorative Nuts (2x)
• Wire Connectors (3x)
• Mounting Bracket (1x)
Requirements
• The light control requires 120-volts AC.
• Some codes require installation by a qualified
electrician.
• This product is intended for use with a junction box
marked for use in wet locations.
© 2016 HeathCo LLC
For easy installation, select an existing light with a wall
switch for replacement. IMPORTANT: Do NOT use with
dimmers or timers.
For best performance, mount the fixture about 8 ft.
(2.4 m) above the ground. Note: If fixture is mounted
higher than 8 ft. (2.4 m), aiming the sensor down will
reduce coverage distance.
Model
8422
Wall Mount
Note: Light fixture and sensor should be mounted as
shown above when installed (depending upon type of
installation). Model 8421 shown above.
1. Remove mounting bracket from back of light fixture.
2. Ensure the long fixture screws are finger tight against
the mounting bracket.
PRE-INSTALLATION
Eave Mount
Mounting
Bracket
Long Fixture
Screws
206150-03A