Abaxis VETSCAN VS2 Manual Del Usuario página 111

7. Installation then begins. When the installer fin-
ishes, click
OK
8. Use the USB cable to connect the VS2 to any available USB port on the computer.
9. Click
Start > Control Panel > Hardware and Sound > Device Manager
10. Click the before Ports (COM & LPT). Look for Abaxis Blood Chemistry Analyzer.
+
Note: If the analyzer does not appear in the device list, do not reinstall the driver. Unplug the
USB cable from the computer, then reinsert it. Check the device manager again.
11. Note the port number to which the analyzer is assigned,
and record this number. You will use this port number
later in this procedure.
(In the example at right, the port is COM4.)
12. Close the Device Manager.
13. Transmit patient results from the VS2 patient archive. For instructions, see
Results" on page
14. Retransmit results from the VS2.
a. In the Home screen, touch the Recall icon.
.
6-9.
Connecting to an External Computer
.
"Transmitting
11-9