Power Cord Safety Tips; Operating Instructions - Utilitech Am04 Guia De Inicio Rapido

1. Use fan only for intended use, as described in instruction manual.
2. To prevent electric shock, do not operate the unit in standing water or on wet surfaces.
3. Never plug in or unplug the unit with wet hands.
4. Do not use this unit in areas where gasoline, paint or other flammable goods and objects are stored.
5. To avoid risk of injury, do not direct air flow at face or body.
6. Do not put fingers or other objects in the unit while in operation and/or when plugged in.
7. Do not operate unit in stacked position. Do not transport units in the stack position as it is not secured.
8. To reduce the risk of fire or electric shock, do not use this unit with any after market speed control devices.
9. To prevent unit from overheating, keep all air intake vents clear at all times during operation. Clogging or blocking
the air intake vents could result in fire or electrical hazard.
10. Do not operate the air mover when the power cord is showing wear and damage, after the appliance malfunctions
or has been dropped or damaged in any manner.
11. To reduce the risk of fire, electric shock or injury to persons, do not plug the unit from power supply before
servicing or cleaning.
12. Unplug unit when not in use. Remove the power cord from the electrical receptacle by grasping and pulling on the
power cord plug-end only, do not pull the cord directly.
13. Do not run the power cord under carpeting. Do not cover the power cord with throw rugs, runners, or similar
covering. Place the power cord away from traffic area to prevent tripping.
14. Do not move or carry the unit while the unit is operating.
15. To reduce the risk of injury, do not remove screens or safety guard from the unit.
16. All units must be supervised while in use.
17. Do not allow children to play with or around the unit at any time. Close supervision is necessary when any
appliance is used by or near children.
18. Do not use fan near curtains, plants, window treatments, etc.
WARNING
• To reduce the risk of fire or electrical shock, do not use this unit with a solid-state speed control device.
• To reduce the risk of electric shock and injury, do not use this unit near a door or window.
• This unit features two built-in receptacle outlets on the side. The total amperage of the unit plus all other devices
plugged into the receptacle must not exceed
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS

POWER CORD SAFETY TIPS

1. Never pull or yank on the cord or the appliance.
2. To insert plug, grasp it firmly and guide it into outlet.
3. To disconnect appliance, grasp plug and remove it from outlet.
4. Before each use, inspect the line cord for cuts and/or abrasion marks. If any are found, this indicates the
appliance should be serviced and the line cord replaced. Please return it to an authorized service representative.
5. Never wrap the cord tightly around the appliance, as this could place undue stress on the cord where it enters
the appliance and cause it to fray and break.
WARNING: BE CERTAIN that the power source for the air mover is 120V AC. DO NOT plug the Fan into 240V or
other power source. The power cord is equipped with a three-prong grounded plug that must be inserted into a
matching receptacle. Under no circumstances should the grounding prong be cut off the plug. Where a two-prong
wall receptacle is encountered, it must be replaced with a properly grounded three-prong receptacle installed in
accordance with National Electrical Code and all applicable local codes. This work must be done only by a qualified
electrician, using copper wire only.
DO NOT USE A THREE-PRONG TO TWO-PRONG ADAPTER. IMPROPER CONNECTION MAY CREATE THE
RISK OF ELECTRICAL SHOCK.

OPERATING INSTRUCTIONS

Turning ON/OFF and Controlling the Fan Speed
1. The unit is pre-assembled and requires no assembly. Remove all packaging and check the exterior of unit and
power cord for shipping damage before plugging into power source.
2. Check household power supply to ensure it matches this unit's specification.
3. Place the unit on a stable, flat and dry surface.
4. Plug in electrical cord into the power outlet.
5. The unit can be adjusted to 3 different angles to direct airflow (0°, 45° and 90°).
6. Turn the switch to desired speed. There are three airflow speeds available (3, 2, 1) with "1" being the lowest
speed and "3" being the highest speed.
7. To reduce the risk of injury, units must be supervised while in use and close supervision is necessary when an
appliance is used near children. Do not allow children to play with or around an air mover at any time.
12 AMPS.
3