inbody InBody120 Manual De Usuario página 9

3. Separate the control handle and the footplate.
4. Connect the adapter ( ) to the power input port, which is located on the rear panel of the InBody120 ( ).
Connect the adapter ( ) to the power cord ( ). Then, plug the power cord ( ) into a grounded 3-socket outlet.
* The InBody120 can be used in connection with the data management software, LookinBody120. For more information, please refer
to 'E. Connecting LookinBody120 (Data Management Software) and Thermal Printer 1. LookinBody120 (Data Management
Software)' in this User's Manual.
UTION NOTE
참 고 주 의
Do not place the InBody120 in a location making it difficult to disconnect the power cord.
•
Do not plug in or pull out the power cord with wet hands. There is a risk of an electric shock.
•
Always use an outlet connected to the rated power (AC 100~240 V). Using other power rated outlets may
•
result in fire or malfunction.
When using a power surge protector, make sure the outlet or the extension cable has adequate power capacity.
•
Do not disassemble or modify the equipment, including internal parts, without written consent from the
•
manufacturer. This may cause electric shock or injury, product malfunction, inaccurate results, and will
void the manufacturer's warranty.
Do not directly contact the InBody120 with any other electronic devices when the InBody120 is on.
•
This may result in an electric shock.
Rear panel
DANGER
Warning
참 조 주 의
Power input port
Ground wire
EN
3-socket outlet
9