Allen + Roth FPDS101BLK Manual De Instalación página 7

INSTALLATION INSTRUCTIONS
5. ASSEMBLING THE BRACKETS
Before attaching the unit to your lintel bar, you have to assemble the brackets.
• You will use either the Long T-Brackets (A) or the Short T-Brackets (B) to attach the unit to your fireplace,
depending on the width of your lintel bar.
• Use a measuring tape to measure the width of your lintel bar, measuring from the back of the lintel bar
to the front of your fireplace.
• Use the width measurement of your lintel bar to determine whether you will need the Long T-Brackets
or the Short T-Brackets.
• Assemble the 2 T-Brackets (long or short) to the 2 Lintel Clamps (C), using the Short Machine Screws (J).
• Do not over-tighten the machine screws yet. Leave them loose. You will tighten them later when you adjust
the width of the clamp.
• Insert the Short Thumb Screws (F) into the back of the Lintel Clamps, as shown.
NOTE: You can assemble the T-Brackets to the Lintel Clamps either face-up or face-down (as shown),
depending on the height of your fireplace. Try it face-up first. If the clamps do not fit your fireplace properly,
you can always go back and re-assemble them face-down.
Hardware Used
A
Long T-Brackets (x2)
C
Lintel Clamps (x2)
J
Short Machine Screws (x2)
F
Short Thumb Screws (x2)
5
Long T-Bracket,
Face-up
Long T-Bracket,
Face-down
B
or Short T-Brackets (x2)
F
C
A
J
7
Short T-Bracket,
Face-up
B
Short T-Bracket,
Face-down