Installation; Installation Site Selection - Argo APOLLO Instrucciones De Instalación

2.4 - DIMENSIONS
EN
Unit: mm

3 - INSTALLATION

3.1 - INSTALLATION SITE SELECTION

AVOID
• Proximity to heat sources, exhaust fans.
• Proximity to combustible materials.
• Direct sunlight.
• Locations where the unit could be splashed with water
or affected by dampness or humidity (i.e. in laundries).
• Unsteady locations that will cause noise or possible
water leakage.
min. 100
2000
min. 80
*
max. 1000
Unit: mm
*
Warning! To facilitate the condensate drain from the service cap, however,
it is advisable to install the unit at a minimum height of 300mm
min. 800
966
IMPORTANT NOTES
• The wall must be a perimeter one.
• Select a sufficiently strong wall to support the weight of
the unit.
• Fix the unit at a minimum height of 8 cm.
• Leave a minimum operation and maintenance area
around the unit.(See figure).
• Make sure that there are no obstacles around the unit
affecting the free circulation of air (curtains,furniture,...).
• Avoid installing the unit with the air flow directly towards
people, electric appliances or heat sources.
• It should not be installed directly above another appliance
(television set, radio, refrigerator, etc.).
80
min. 80 / max. 1000
*
6
210
100