Singer XL-580 Manual De Instrucciones página 94

1. If stitches are missing.
If the embroidery machine detects that the thread has
broken, it may continue to embroider up to about eight
automatically stops.
In this case, use the following procedure to step back
though the embroidery design to the area where you
want to resume stitching.
back through the embroidery design. The hoop will
move back one stitch at a time. Continue stepping
back through the embroidery design until the blank
area has been passed over.
2. Restart the embroidery machine and continue
embroidering.
2. Computer screen says thread is broken,
machine lights are flashing lights and
making a beeping sound, but thread is
not broken.
Upper thread is not in the thread tension. Rethread
Placing the small net that is supplied with the accessories
over the spool of thread may ensure that the thread is
unwinding properly.
the stitching is either too tight or not tight
enough.
T h e s o f t w a r e w i l l r e c a l c u l a t e t h e s t i t c h o n a n
imported design when sizing, but only when using
of re-sizing up to 149% and down sizing to 51% and
while still being able to re-calculate the stitches correctly.
88
Embroidering direction
1
3
Blank stitches resulting from thread breakage
Puntadas en blanco resultantes de ruptura de hilo
Embroidered section
2
4
6
8
5
7
automatically stop
Para automáticamente
Reverse stitch button
Interruptor de puntadas
hacia atrás