Control Elements On The Rc Panel Basic, Rc Panel Basic /Bt, Rc Panel Basic Tig /Tmc; General; Adjuster Functions During Mig/Mag Welding - Fronius RC Panel Basic Manual De Instrucciones

Control elements on the RC Panel Basic, RC Pa-
nel Basic /BT, RC Panel Basic TIG /TMC

General

NOTE!
See the power source Operating Instructions for more details of the welding pa-
rameters listed below.
Adjuster func-
The adjuster performs different functions depending on the welding process.
tions during
MIG/MAG wel-
ding
(1)
(2) - Correcting the arc length
(during MIG/MAG synergic welding - Standard, Puls, PMC, LSC)
- = shorter arc length
0 = neutral arc length
+ = longer arc length
- Setting the welding voltage
(during MIG/MAG standard manual welding)
(1) - Setting the welding power
(during MIG/MAG synergic
welding - Standard, Puls,
PMC, LSC)
- Setting the wire feed
speed
(during MIG/MAG stan-
(2)
dard manual welding)
33