Sd Cycle; Reset; Send Test Photo; Firmware Version - Zeiss Secacam 7 Instrucciones De Uso

CAUTION!
Please use the PIN code option very carefully. If you forget the selected PIN, the camera is
also useless for you. In this case please contact our customer service. If you have booked a
corresponding data plan, you can also deactivate the PIN request via the ZEISS Secacam app.

5.20 SD cycle

By setting this menu item to "On", you prevent new recordings from being made when the memory card is
full. Otherwise the oldest recordings are overwritten by new ones.

5.21 Reset

If you select "Yes" under this menu item and confirm the selection with "OK", all settings are reset to the
delivery status. The date and time are not affected.

5.22 Send test photo

(This menu item can only be selected if mobile is switched on.)
If you want to test whether sending recordings via mobile works as desired, you can take a test photo.
Note: We recommend that you familiarize yourself with the Pause capture, Time lapse and Timer functions
mentioned above when using mobile mode. The functions will help you take and send the optimal number
of photos.

5.23 Firmware version

The firmware version currently installed on the camera can be seen here. The ZEISS Secacam is continuously
being updated. Please visit www.zeiss.com/cop/downloads and check if software updates with a higher
version number are now available for your camera.

5.24 Firmware update

Note: This menu item can only be selected if there is a new firmware version on the SD card. The batteries
need to be fully charged in order to install the update.
We are continuously updating our cameras. New firmware versions with optimizations or even new functions
can be downloaded from www.zeiss.com/cop/downloads.
CAUTION!
Please follow the instructions on the website carefully, otherwise your camera may be
damaged!
37