Publicidad
Idiomas disponibles
Idiomas disponibles
surrounding objects and surfaces. Plug in the appliance, switch ON the appliance by pressing the
On/Off switch (O/I) and let the appliance produce steam until the vinegar/water solution is used up.
Repeat the above procedures as many times as necessary until a normal steam flow rate is
achieved.
Fill the water tank with fresh water and rinse it out.
Fill the water tank with fresh water. Attach it to the appliance and let steam escape through the
system until the water tank is empty.
WARNING
Do not leave the steamer unattended while removing limescale and/or during use.
NOTICE:
Perform a test clean on a suitably insulated area after any limescale removal to ensure there
is no debris in the system.
WARNING
RISK OF BURNS
Cleaning clogged steam accessories:
Due to the high mineral content of water in some areas, you will notice less steam coming out of the
portable steamer accessories. This can be caused by a build-up of scale in the tip of the mouthpiece.
How to remove limescale: We recommend using a spray lubricant. Inject a few drops of lubricant into
the tip of the straight nozzle. After injecting lubricant into the part, fill the steamer with water as
instructed and run a continuous stream of steam through the affected accessory for several minutes to
remove the deposits. Once the steam path is clean, aim the steamer at a neutral surface or cleaning
cloth to ensure no debris is emitted.
WE RECOMMEND PERFORMING THIS PROCEDURE IN A PROTECTED AND WELL VENTILATED
AREA.
Maintenance of microfibre cloths:
Machine wash at 60℃ (140℉)
Do not bleach
Do not use fabric softener
TROUBLESHOOTING GUIDE
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY, UNPLUG THE POWER CORD
BEFORE MAINTENANCE.
Problem
THE DEVICE DOES
NOT TURN ON:
REDUCED STEAM
OR NO STEAM:
STEAM ESCAPES
FROM
CONNECTION:
THE CLEANING
CLOTH BECOMES
WET:
Possible Cause
The device is not Plugged in or
turned ON
Water tank is empty
Blocked steam nozzle
Lime scale deposit
Attachment is not connected
properly
Debris or obstacles at the
connection points
The cloth gets saturated with water
Solution
Make sure the device is plugged into a
proper
Fill the water tank
Remove mop head and clean the nozzle.
Follow cleaning procedure in this user
guide to remove lime scale
Turn the device OFF, allow to cool down,
disconnect the accessory and reattach it
properly.
Remove the accessory and check and
clean the connection points.
Remove wet cloth and replace with a
new cloth cleaning cloth (optional) or
allow cloth to cool, wring out and
reattach
13
outlet and the switch is ON
Publicidad
