Functional Description - Porter Cable Pc600D-Ca Manual De Instrucciones

fuNctIoNAl deScRIPtIoN

figure A
1. Variable speed switch
2. Lock-on button
3. Reversing lever
4. Keyless chuck
5. Belt clip
B
ASSeMBly
WARNING:
To reduce the risk of injury, before assembly, make sure that the tool is
switched off and unplugged.
INSeRtING A dRIll BIt oR otHeR AcceSSoRy (fIGuRe B)
WARNING:
do not attempt to tighten drill bits (or any other accessory) by
gripping the front part of the chuck and turning the tool on. Damage to the chuck and
personal injury may occur when changing accessories.
WARNING:
Always ensure the bit is secure before starting the tool. A loose bit
may eject from tool causing possible personal injury.
Your tool features a keyless chuck (4) for greater convenience. To insert a drill bit or
other accessory, follow the steps listed below.
• Grasp the rear half of the chuck with one hand and use your other hand to rotate the
front half counterclockwise, as shown in figure B. Rotate far enough so that the chuck
opens sufficiently to accept the desired accessory.
• Insert the bit or other accessory about 3/4 inch (19 mm) into the chuck and tighten
securely by holding the rear half of the chuck and rotating the front portion in the
clockwise direction.
• To release the accessory, repeat step 1 listed above.
ReMovING ANd AttAcHING tHe cHuck (fIGuRe c)
• Open the chuck as far as possible.
• Remove the chuck retaining screw, located in the chuck, by turning it clockwise using a
screwdriver (lefthand thread).
• Tighten an Allen key of 1/4 inch or greater size (not supplied) into the chuck and strike it
with a soft hammer in a counterclockwise direction as shown.
• Remove the Allen key.
A
C
5
4
3
D
3
5
2
1
1