Exogen Cleaning - Bioventus Exogen Guia Del Usuario

EXOGEN Cleaning

After treatment is complete, you must clean the
transducer after each use.
1. Squeeze tabs to open the cap on 2. Gently remove the transducer from the port.
the port. Do not yank the cord! Pulling hard on the
cord to remove the transducer may cause
the cord to detach from the transducer and
require your EXOGEN to be serviced.
11
If You Have a Cast
Follow steps 1-3 (previous page), and then do the
following instead of step 4:
3. Wipe off any gel on the transducer
with a soft cloth. You do not need
any cleaning fluid.
4. Remove the strap and clean any
gel from your skin and strap with
a soft cloth.
5. Place EXOGEN, the strap and gel
back into the carrying case until you are
ready to treat again.
4. Carefully clean any gel from your cast, skin 5. Insert the felt plug, with the tab up, into the
and port with a soft cloth. port. This plug helps prevent swelling in the
cast when you are not using EXOGEN.
6. Snap the cap shut.
7. Place EXOGEN and the gel back into the
carrying case until you are ready
to treat again.
12