Pump Operation; Single Leg Operation - Aircast Venaflow Elite 30BI-S Manual Del Operador

Pump Operation

1) To turn the device on, press
lights and green light above
2) Once device is powered on, system will immediately enter cuff detection mode
which means the system will be detecting whether or not there are cuffs
attached . Display will read "Detecting Cuffs" and will display percentage of
detection complete . Once it reaches 100%, the display will then transition to the
standard display screen .
3) Any changes to cuff configuration requires that the device be powered off and
restarted in order to detect the new configuration .
4) To turn the device off, press
lights and green light above
5) To shut down the power completely, disconnect the power plug by removing it
from the AC socket .

Single Leg Operation

1) Cuffs should be attached prior to powering on the device . Once powered on, the
device will automatically detect if one or two cuffs are attached .
2) Any changes to cuff configuration requires that the device be powered off and
restarted in order to detect the new configuration .
3) Either port may be used for single leg operation . The system will automatically
detect which one is in use .
4) Single and dual leg operation are available in both standard rapid mode and S
mode operation .
Patient Compliance Counter Reset
To reset the patient compliance counter, press
minutes and seconds will reset .
ENGLISH
. The graphical display, green pump indicator
button will turn on .
. The graphical display, green pump indicator
button will turn off .
for 1 second and release . The hours,
11