Configuration Lab 945; Basic Settings; Configuration Of The Fixed Temperature - Xylem SI Analytics Lab 745 Manual De Instrucciones

10.5

Configuration Lab 945

10.5.1 Basic settings

Via (CONF) you will go to the menu item "Configuration".
The entire structure of the menu (CONF) is displayed graphically in  10.4.
The following device-relevant basic settings can be configured:
data logg.
temperature
main value
general.

10.5.2 Configuration of the fixed temperature

The measured conductivity value can be put out temperature-compensated. For this, the temperature
of the measuring and calibration media must be measured or set up as a fixed temperature.
If the fixed temperature is activated, it is used for temperature compensation.
> The message "FIX" will appear in the top right side of the display.
> Configuration of the fixed temperature:
"Temperature" > "Fixed temperature"
"Temperature" > "Temp. value"
Via (INFO) or (CAL) you select the position to change.
Via (CONF +1) or (LOG -1) you change the position.
(ON/OFF) confirms and saves your setting.
(MEAS) terminates the entry dialog without transferring the value.

Data logger ( Chapter 5)

Temperature

main value

General ( Kapitel 4)
, then select the fixed temperature value.
>
, then select activate / deactivate.
>
71