Uline H-5333 Manual Del Usuario

H-5333, H-5334
AUTOMATIC PAPER
CRUMPLER – FLOOR STANDING
OPERATING ISSUE
No power to machine.
Paper not pulling through
head.
Paper exposed in exit shoot,
but not being pulled through
with foot pedal operation.
PAGE 1 OF 6
1-800-295-5510
uline.com
TROUBLESHOOTING
CAUSE
Unit not plugged in.
Motor not connected to power box.
Machine needs to be reset.
Foot pedal not connected to power
box.
Paper wadded in entrance funnel,
not flat.
Paper is caught or not threaded
through enough.
Insufficient drive wheel tension.
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
RECOMMENDATIONS
Connect power cord to standard 115V
outlet.
Connect blue motor connector plug
to the blue plug on the power box;
make sure it has clicked into place.
Check white two amp reset button on
power box to make sure it is recessed.
Connect the gray foot pedal
connector plug to the gray plug
on the power box; make sure it has
clicked into place.
Make sure paper is flat and folded in
on itself in the entrance funnel.
Turn threading disk clockwise to
advance paper.
Tighten the bolts on the top of the
head a quarter turn at a time. Repeat
as needed until drive wheels grip
paper.
0321 TH-5333