Uline H-16 Guia De Inicio Rapido

H-16
BETTER PACK
CADILLAC 755
TAPE DISPENSER
UNPACKING NOTES
When unpacking your new electric machine, check the
following before discarding packaging material:
1. There should be two brushes in the water tank.
2. The upper tape plate is held in position by
packaging materials but may have been dislodged
in shipping. Remove all holding material before
using machine.
SETTING UP YOUR MACHINE
1. If the upper plate has been dislodged in shipping,
replace as follows: With the center slot toward the
front of the machine, slide under feed wheel shaft
from the rear until the cut-out portions on sides are
over the retaining "buttons." Drop plate and slide
forward so that end of plate is under the rod just to
the rear of the shear and the back end is under the
"buttons."
2. Remove tank and brushes. Wash brushes thoroughly
in warm water and soap or mild detergent. Replace
brushes in water tank. Note the two brushes are
beveled. Replace them in tank, being sure each
brush is positioned with the high side toward the
front of the tank. Replace tank and brushes in the
machine.
3. Fill bottle with water and place in the bottle holder
so the spout of the bottle is in the tank. Set correct
water level. (See adjustments, water level.)
PAGE 1 OF 9
1-800-295-5510
uline.com
INSTRUCTIONS
4. Adjust roll guides inside rear of machine to proper
width for tape. (See roll guide adjustment.)
5. Loading tape: Take the roll and unwind about 18".
Place the roll in the basket so that the strip unwinds
off the rear of the roll as the leading end is brought
up toward the front of the machine with gummed
side down. Thread tape over the roller at the upper
rear and slide leading edge forward under upper
tape plate and feed wheel.
6. Set pressure plate weight and top heater
temperature. (See adjustments, moistening and top
heater settings.)
7. Electrical Connection
a. Plug Machine into wall outlet.
WARNING! For your safety all the metal parts of
this machine are electrically grounded through
a 3-wire power supply cord and a 3-prong
grounding type plug, which must be plugged
into a 3-wire grounded type receptacle. If
you are not sure the electrical system in your
building is properly grounded, call a licensed
electrician.
b. When all connections have been made, turn on
the power switch at the right front of machine.
Pilot light should light and indicates the machine
is ready for operation.
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
0521 IH-16