Detaching The Cleaning Strips; Operation; Cleaning The Pool - Steinbach Poolrunner Battery Basic Manual Original

Detaching the cleaning strips

1. Pull on the frames of the cleaning strips
and take them out of the bottom
15
part .
3
The cleaning strips are detached.

Operation

Check the following before each use:
- Is there visible damage on the device?
- Is there visible damage on the control elements?
- Do all individual parts function?
- Are the accessories in perfect condition?
- Are all cables in perfect condition?
Do not start up a damaged device or damaged accessories. Have them checked by the
manufacturer or its customer service or a qualified service technician.

Cleaning the pool

Observe the following before cleaning your pool:
- We recommend thoroughly cleaning the device before using it for the first time.
- Remove any cover or film from the pool.
- Remove obstacles (such as a ladder) from the pool.
- Switch off the filter system at least one hour before the start of cleaning so that
particles in the water can settle on the floor.
- Never let the device run outside of the water as this can cause damage even after a
short time.
Proceed as follows to clean your pool:
1. Insert the filter unit.
2. Place the device in the pool and switch it on.
8
3
15
37