Uline H-5580 Manual Del Usuario

H-5580, H-5581, H-5582
H-5583, H-5584, H-5585
BALL TRANSFER TABLES
TOOL NEEDED
9/16" (14mm) Wrench
BOLTING TABLE FRAME(S)
TO H-STAND LEG SUPPORTS
NOTE: H-Stands are sold
separately. Hardware
included: 4 hex head bolts,
4 flange nuts.
1. Hardware is pre-screwed into the
tops of the H-Stands. Remove
the hardware. (See Figure 1)
2. Bolting two H-Stands to one
table frame: Position
H-Stands on the end of the
table frame. Fasten bolts
through table and H-Stand.
(See Figure 2)
Bolting a single H-Stand to
two table frames: Position
the H-Stand halfway
between the end of two
table frames, lining up one
hole on each table with the
H-Stand. Fasten bolts through
tables and H-Stand.
(See Figure 3)
NOTE: Each table
frame includes
mounting holes for
an optional center
leg support. Adding
a third support
increases weight
capacity.
PAGE 1 OF 3
1-800-295-5510
uline.com
ASSEMBLY INSTRUCTIONS
CONNECTING MULTIPLE TABLES TOGETHER
1. Remove pre-screwed hardware. Fasten bolts through
the ends of both frames. (See Figure 4).
Figure 1
Figure 2
Figure 3
Para Español, vea página 2.
Pour le français, consulter la page 3.
Figure 4
0621 IH-5580