Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Installation
Instructions
If you have questions, call GE Appliances at 800.GE.CARES (800.432.2737) or Visit our Website at:
GEAppliances.com.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IN THE COMMONWEALTH OF
MASSACHUSETTS:
This product must be installed by a licensed
plumber or gas fitter.
When using ball-type gas shut-off valves, they shall
be the T-handle type.
A flexible gas connector, when used, must not
exceed 3 feet.
IMPORTANT
for local inspector's use.
IMPORTANT
codes and ordinances.
IMPORTANT
appliance shall be conducted according to the
manufacturer's instructions.
Note to Installer – Be sure to leave these
instructions with the Consumer.
Note to Consumer – Keep these instructions for
future reference.
Skill level – Installation of this appliance requires
basic mechanical skills.
Completion time – 1 to 3 hours
Proper installation is the responsibility of the
installer.
Product failure due to improper installation is not
covered under the Warranty.
WARNING
This appliance must be properly
grounded.
31-2000792 Rev. 0 07-20
— Save these instructions
— Observe all governing
— Leak testing of the
24" Gas Built-In Oven
JGRP20
FOR YOUR SAFETY
WARNING
not followed exactly, a fire, explosion or gas leak may
result, causing property damage, personal injury or
death.
DO NOT STORE OR USE GASOLINE OR OTHER
FLAMMABLE VAPORS AND LIQUIDS IN THE
VICINITY OF THIS OR ANY OTHER APPLIANCE!
WHAT TO DO IF YOU
SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch; do not use any
phone in your building.
Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
If you cannot reach your gas supplier, call the fire
department.
Installation and service must be performed by a
qualified installer, service agency or the gas supplier.
Be sure your oven is installed properly by a
qualified installer or service technician.
Be sure the oven is securely installed in a cabinet
that is firmly attached to the house structure.
Weight on the oven door could cause the oven to
tip, resulting in serious personal injury or death.
Never allow anyone to climb, sit,
If the information in this manual is
1
Tabla de contenido
loading

Resumen de contenidos para GE JGRP20

  • Página 11: Antes De Empezar

    Horno A Gas Instrucciones Empotrado de 24” de Instalación JGRP20 ¿Preguntas? Llame al 1.800.GE.CARES (800.432.2737) o bien visite nuestra página Web: GEAppliances.com ANTES DE EMPEZAR: PARA SU SEGURIDAD: ADVERTENCIA Lea estas instrucciones y las advertencias Si la información en este manual completa y cuidadosamente.
  • Página 12: Preparación De Instalación

    Preparación de Instalación LISTA DE HERRAMIENTAS REQUERIMIENTOS DE GAS Usted debe cumplir con los códigos locales cuando instale su horno. Consulte con su compañía de gas local acerca de las leyes y ordenanzas locales que se aplican en su área. Si no existen códigos locales, Gafas de seguridad usted debe cumplir con el National Fuel Gas Code ANSI/Z223.1 –...
  • Página 13: Prepare La Abertura

    Instrucciones de Instalación El gabinete debe tener fondo, posterior y lados 3 PREPARE LA ABERTURA sólidos. El fondo debe ser sólido, a nivel del piso o con el borde sólido del fondo del corte. Todas las aberturas del gabinete deben estar selladas en el momento de la instalación para prevenir corrientes de aire.
  • Página 14: Instalación Del Horno

    Instrucciones de Instalación INSTALACIÓN DEL HORNO CONEXIONES ELÉCTRICAS CONEXIONES DEL GAS Un abastecimiento y receptáculo eléctrico adecuado debe ser ADVERTENCIA usado para operar las partes eléctricas de su horno. No haga funcionar los quemadores de este horno cuando use gas LP (embotellado) antes A.
  • Página 15: Revise Que No Hayan Escapes

    Instrucciones de Instalación INSTALACIÓN DEL HORNO (Cont.) CONEXIONES DEL GAS (Cont.) REVISE QUE NO HAYAN ESCAPES I. Coloque el horno en el corte. ADVERTENCIA ¡NO USE UNA LLAMA ABIERTA J. Nivele el horno: PARA VER SI EXISTEN ESCAPES DE GAS! 1.
  • Página 16: Cómo Revisar Las Llamas De Los Quemadores A Gas Natural

    Instrucciones de Instalación INSTALACIÓN DEL HORNO (Cont.) CÓMO REVISAR LAS LLAMAS DE CÓMO AJUSTAR LAS LLAMAS DEL LOS QUEMADORES A GAS QUEMADOR (Cont.) NATURAL E. Use un destornillador para soltar el tornillo del obturador de aire. El horno viene ajustado de fábrica para ser usado con gas 1.
  • Página 17: Cómo Colocar Bien El Horno

    Instrucciones de Instalación INSTALACIÓN DEL HORNO (Cont.) CÓMO COLOCAR BIEN EL HORNO REVISE LOS PASOS Revise varias veces para asegurarse que todo en esta guía IMPORTANTE: Saque todos los materiales ha sido completado. El revisar los pasos le asegurará la de empaque y la literature del horno antes de utilización segura del horno.
  • Página 18: Cómo Hacer La Conversión Para Gas Lp

    Instrucciones de Instalación CÓMO HACER LA CONVERSIÓN PARA GAS LP ADVERTENCIA AJUSTE EL REGULADOR DE Si usted va a usar gas LP PRESIÓN DE GAS NATURAL A (embotellado), todos los ajustes descritos más abajo deben hacer antes de hacer cualquier ajuste a los GAS LP(Cont.) quemadores o usar el horno.
  • Página 19: Para Quemadores Para Hornear Y Asar

    Instrucciones de Instalación CÓMO HACER LA CONVERSIÓN PARA GAS LP (Cont.) PARA QUEMADORES PARA AJUSTE EL OBTURADOR DE HORNEAR Y ASAR AIRE NOTA: Las llamas para hornear y asar se deberían revisar la tapa del orificio en dirección de LP, aprox. 1 1/2 vuelta, con la puerta cerrada para revisar correctamente las hasta que quede apretada.
  • Página 20 Instrucciones de Instalación CÓMO HACER LA CONVERSIÓN PARA GAS LP (Cont.) AJUSTE EL OBTURADOR DE AIRE AJUSTE EL OBTURADOR DE (Cont.) AIRE (Cont.) QUEMADOR PARA HORNEAR QUEMADOR PARA ASAR A. El quemador para asar está ubicado y es accesible en la Obturador de Aire Cubierta...

Este manual también es adecuado para:

Jgrp20wejwwJgrp20bejbbJgrp20senss

Tabla de contenido