LUND Interceptor Instrucciones De Instalación

For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-328-5863.
Important Safety Information
• CAUTION - Before driving, ensure that the hood shield is properly anchored to vehicle.
• Do not use automatic "brush-style" car washes.
• Do not use cleaning solvents of any kind.
• Periodically check all components for tightness.
Contents
NOTE: Actual product may vary from illustration.
Hood Shield
Tools Required
Car Wash Supplies
Preparation Before Painting / Installation
• A trial fit is recommended to ensure proper positioning and fit.
• Check fit of parts before painting as we will not accept the return of modified or painted parts.
• Wash your vehicle's hood to remove any debris and/or dirt.
• Dry the hood with a clean towel.
• Do NOT install hood shield if vehicle does NOT have a factory installed hood seal / gasket.
Installation Steps
NOTE: Do NOT install hoodshield if vehicle does NOT have a factory
installed front hood seal / gasket.
1
Installation Instructions
Interceptor
NOTE: Actual application may vary slightly from illustrations.
Open Hood.
™
Bump On x4
Clean Towel
Remove (4) plastic seal retaining fasteners that align with the pre-
drilled holes in the hood shield. Next, carefully separate the hood
seal / gasket from the areas of the hood that align with the hood
NOTE: Exercise extreme caution not to tear
2
or damage the hood seal / gasket when
seperating from hood.
Page 1 of 2
I - Sheet Number LUNDBF95 Rev.C
Plastic Washer x4
(98032)
Appropriate hand tools
shield flange.
Screw x4
(98046)