LUND Interceptor Instrucciones De Montaje

For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-241-7219.
Important Safety Information
• CAUTION - Before driving, ensure that the hood shield is properly anchored to vehicle.
• Do not use automatic "brush-style" car washes.
• Do not use cleaning solvents of any kind.
• Periodically check all components for tightness.
Contents
NOTE: Actual product may vary from illustration.
Hood Shield
Tools Required
Car Wash Supplies
Preparation Before Painting / Installation
• A trial fit is recommended to ensure proper positioning and fit.
• Check fit of parts before painting as we will not accept the return of modified or painted parts.
• Wash your vehicle's hood to remove any debris and/or dirt.
• Dry the hood with a clean towel.
Installation Steps
Clean the upper leading edge of the hood surface
with an alcohol pad.
1
Installation Instructions
Interceptor
Hood Insert x2
(39-4150)
Clean Towel Appropriate hand tools
NOTE: Actual application may vary slightly from illustrations.
™
Washer x2 Screws x2
(98022) (98023)
Alcohol Pad x2 Bracket x3
(39-1977)
Grease pencil
Raise Hood and clean under leading edge of hood
2
Page 1 of 3
I - Sheet Number I-1207 Rev.B
Bump On x2 Protective Film x3
(44-4132)
Machine Screw x3 Washer x3
(04-4128) (37-4106)
Tape
surface with an alcohol pad.