Uline MONARCH 1115 Manual De Instrucciones

π H-708
MONARCH 1115
TWO LINE LABEL GUN
CHANGING THE INK ROLLER
TOP COVER
LATCH
Figure 1
BUTTON
Figure 2
CARRIER
Figure 3
SETTING PRINT CHARACTERS
Figure 4
3. Repeat steps 1-2 for each band.
4. Push in the knob when you are done.
PAGE 1 OF 9
1-800-295-5510
uline.com
INSTRUCTIONS
1. Push the two latch
buttons in toward label
roll and swing top
cover away from print
head. (See Figure 1)
2. Insert folded backing
paper between ink
roller and carrier. Pull
to snap old ink roller
free. (See Figure 2)
3. Cut off end of ink
roller package. Using
package to protect
fingers, slide carrier
into package and
snap new ink roller into
place. (See Figure 3)
4. Snap top cover closed.
1. Pull knob until
indicators are on the
desired band.
(See Figure 4)
2. Turn the knob until
the desired character
appears black on a
white background
between the indicators.
(To print a blank, select
a blank space for that
band).
LOADING LABELS
1. For loading a new roll of labels, tear off and discard
the first 10 inches of label and liner. Tear backing
evenly between cuts.
2. Peel the first 12 labels from liner and discard.
FEED GUIDE
HUB
Figure 5
BRAKE
WHEELS
LABEL EXIT
TRIGGER
Figure 6
LABEL EXIT
PLATE
LOOP
Figure 7
SLOT
BACKING
Figure 8
PAPER EXIT
9. Remove any loose labels.
NOTE: If backing paper does not become taut
and exit at rear: Turn labeler upside down,
squeeze trigger and pull backing paper out of
slot. Repeat steps 6, 7 and 8.
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
3. Place the label roll
between the hubs and
click into place. (See
Figure 5)
4. Feed the label strip
through the hole in
the feed guide.
(See Figure 5)
5. Squeeze and hold the
trigger while feeding
the label strip into the
slot below the brake
wheels until about 6
inches come out of the
front. (See Figure 6)
6. Feed label strip under
the plate and pull
through until loop is
removed. (See Figure 7)
7. Squeeze and hold the
trigger while feeding
the label strip into the
slot below the arrow
until it stops/hits the
back. (See Figure 8)
8. Hold the strip in place
and squeeze the trigger
eight times or until
backing paper feeds
through the rear exit.
0821 IH-708