Uline MONARCH 1110 Instrucciones

H-707
MONARCH 1110
ONE LINE LABEL GUN
CHANGE THE INK ROLLER
Figure 1
Figure 2
Figure 3
SET PRINT CHARACTERS
Figure 4
7. Repeat steps 1-2 for each band.
8. Push in the knob when you are done.
PAGE 1 OF 9
1-800-295-5510
uline.com
INSTRUCTIONS
1. Turn latch to release ink
roller door and carefully
pull ink roller completely
out of labeler.
(See Figure 1)
2. Insert folded backing
paper between ink roller
and carrier. Pull to snap
old ink roller free.
(See Figure 2)
3. Cut off end of ink
roller package. Using
package to protect
fingers, slide carrier into
package and snap new
ink roller into place.
(See Figure 3)
4. Slide ink roller door back
into place and turn latch
to lock.
5. Pull knob until indicators
are on the desired band.
(See Figure 4)
6. Turn the knob until
the desired character
appears black on a
white background
between the indicators.
(To print a blank, select
the blank space for that
band).
LOAD LABELS
1. For loading a new roll of labels, tear off and discard
the first 10 inches of label and liner. Tear backing
evenly between cuts.
2. Peel the first 12 labels from liner and discard.
HUB
Figure 5
BRAKE
WHEELS
LABEL EXIT
TRIGGER
Figure 6
LABEL EXIT
PLATE
LOOP
Figure 7
Figure 8
SLOT
BACKING
PAPER EXIT
NOTE: If backing paper does not become
taut and exit at rear, turn labeler upside down,
squeeze trigger and pull backing paper out of
slot. Repeat steps 5, 6 and 7.
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
3. Place the label roll
between the hubs and
click into place.
(See Figure 5)
4. Squeeze and hold the
trigger while feeding the
label strip into the slot
below the brake wheels
until about 6 inches
come out of the front.
(See Figure 6)
5. Feed label strip under
the plate and pull
through until loop is
removed. (See Figure 7)
6. Squeeze and hold the
trigger while feeding the
label strip into the slot
below the arrow until it
stops/hits the back.
(See Figure 8)
7. Hold the strip in place
and squeeze the trigger
eight times or until label
strip feeds through the
rear exit. (See Figure 8)
8. Remove any loose labels.
0421 IH-707