Wayne CWS Series Manual De Instrucciones De Operación Y Piezas

Operating Instructions and Parts Manual
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or
property damage! Retain instructions for future reference.
Description
Jet pumps are single stage domestic water
pumps designed for pumping potable water
in applications where the water is up to 100
feet below pump center line. A pressure
switch is a standard feature. A built-in
control valve is available on deep well
pumps. Deep well pumps can be mounted
to either a pre-charged, conventional type,
or free standing pressure tank.
Unpacking
After unpacking the jet pump, carefully
inspect for any damage that may have
occurred during transit. Check for loose,
missing or damaged parts.
Safety Guidelines
This manual contains information that is
very important to know and understand.
This information is provided for SAFETY
and to PREVENT EQUIPMENT PROBLEMS.
To help recognize this information,
observe the following symbols.
Danger indicates an
imminently hazardous
situation which, if NOT avoided, WILL result
in death or serious injury.
Warning indicates a
potentially hazardous
situation which, if NOT avoided, COULD
result in death or serious injury.
Caution indicates a
potentially hazardous
situation which, if NOT avoided, MAY result
in minor or moderate injury.
Notice indicates
important
information, that if NOT followed, may
cause damage to equipment.
NOTE: Information that requires special
attention.
© 2011, WAYNE/Scott Fetzer Company.
Convertible Well Jet
Pump Water Systems
General Safety
Information
CALIFORNIA PROPOSITION 65
including lead, known to the State of
California to cause birth defects and
other reproductive harm. Wash hands
after handling.
GENERAL SAFETY
1. Read all manuals included with this
product carefully. Be thoroughly
familiar with the controls and the
proper use of the equipment.
2. Know the pump application,
limitations and potential hazards.
to match the system pressure rating and
the maximum flow rate.
or explosive fluids such as gasoline,
fuel oil, kerosene, etc. Do NOT use in
explosive atmospheres. Pump should be
used to pump ONLY clear water. Failure
to follow this warning WILL result in
death or serious injury.
pressure from the system before
attempting to install, service, relocate
or perform any maintenance. Lock the
power disconnect in the open (off)
position. Tag the power disconnect
to prevent unexpected application of
power.
to prevent entrapment of swimmers.
3. Drain all water from the system
before servicing.
4. Periodically inspect pump and
REMINDER: Keep your dated proof of purchase for warranty purposes!
Attach it to this manual or file it for safekeeping.
For parts, product & service information
visit www.waynepumps.com
5. Personal Safety:
This product
contains chemicals,
6. Do NOT pump chemicals or corrosive
ALWAYS install a
pressure relief valve
7. When installing pump, cover the
Do NOT use to
pump flammable
8. Always test the water from the well
Disconnect power
9. Complete pump and piping system
and release all
10. Do NOT run the pump dry or
Install a screen
around the inlet pipe
installation only. Failure to install
indoors will significantly increase the
risk of injury or death from electrical
shock.
CWS Series
system components. Perform routine
maintenance as required (See
Maintenance, page 6).
a. Wear safety glasses at all times
when working with pumps.
b. Keep work area clean, uncluttered
and properly lighted replace all
unused tools and equipment.
c. Keep visitors at a safe distance
from work area.
d. Make the workshop child proof:
use padlocks, master switches and
remove starter keys.
liquids. Pumping these liquids
shortens the life of the pumps seals
and moving parts and will void the
warranty. Pump ONLY clear water.
well to prevent foreign matter from
falling into well and contaminating
the water and damaging internal
mechanical pumping components.
for purity before use. Check with
local health department for test
procedure.
MUST be protected against below
freezing temperatures. Freezing
temperatures could cause severe
damage and void the warranty.
damage will occur and will void
warranty.
This pump is
designed for indoor
340007-001 7/11