ABB RENCLOSURERAIL Instrucciones De Instalación Y Mantenimiento

—
I N S TA L L AT I O N A N D M A I N TA N A N C E I N S T R U C T I O N S
RENCLOSURERAIL
H A Z A R DOUS VO LTAG E .
W I LL C AUS E S E V ER E
I N J U RY O R D E ATH .
Turn OFF power supplying this
equipment before working inside.
Kit Contains
Enclosure Rail
Screws
Note: Install enclosure rail before mounting
or powering the equipment
Instruction
1. Locate position of enclosure rail to align with the
fastening holes in the back of the enclosure
2. Use two screws provided to fasten enclosure rail
to the enclosure. Torque to 50 in-lbf.
CAUTION: Units between 30 and 36 inches wide re-
quire 2 enclosure rails. Units over 37 inches wide
require 3 enclosure rails.
—
ABB Inc.
305 Gregson Drive
Cary, NC 27511
United States
electrification.us.abb.com
3
6
—
We reserve the right to make technical
changes or modify the contents of this
document without prior notice. With
regard to purchase orders, the agreed
particulars shall prevail. ABB AG does
not accept any responsibility whatsoever
for potential errors or possible lack of
information in this document.
Please read these instructions
completely before installing
or removing device. Improper
installation could be hazardous
to personnel and/or equipment.
We reserve all rights in this document
and in the subject matter and illustrations
contained therein. Any reproduction,
disclosure to third parties or utilization
of its contents – in whole or in parts –
is forbidden without prior written
consent of ABB AG. Copyright© 2024 ABB
All rights reserved